These auto restoration and hot rod build tips are courtesy of Hot Rods

During final polishing mask the entire car with plastic and tape all the gaps to avoid polishing compounds from entering in and under trim gaps etc.

When painting small parts we recommend using 1/8th to 1/4 inch hooks to stabilize the parts. Notice the hooks are taped at the top of the rack as this keeps them from swaying during the force of air from the spray gun allowing a smooth paint job.

Often the edge of a panel will be wavy or unstable compared to the center especially on open panels that are not folded back. The use of a mig welder to spot a few areas and then cool with a wet rag will stiffen the panel just enough. Simply grind them back down slowly to the surface before body work and priming.

When buffing small and or larger stainless trim parts use various sizes of wood to bolt or screw them down to eliminate holding the actual part and tweaking it during the natural heat build that occurs.